V2 Flexy 230volt control panel

V2 Flexy control panel great as a replacement controller for gates requiring an analogue panel . 2 remote controls also included to match controller.

 230V power supply for 2 single-phase motors

Built-in receiver (433,92 MHz) Possibility to store up to 240 Personal Pass transmitter RJ45 connector to connect the control unit to the programmer PROG2 via standard network cable (UTP)

Start, pedestrian start and stop controls from transmitter Open/close limit switch inputs

230V flashing light output (use flashing lights with intermittence)

Courtesy light output (also controllable by transmitter) Safety device test before any opening Leaf slow-down function in limit switch area to prevent noisy closures and rebounds

Monitoring of input status shown by LEDs

Note force adjustment available with adjustable pots but no encoder detection or force reversal built in.

Suitable for most gates if in doubt please check.